How to mix chemicals in kit
 

knowledgebase

Beth Dusch
Beth Dusch
Offline
Resolved
0 votes
Experiments call for using pipette to add drops of potassium hexacyanoferrate solution. But can not find in the manual how to mix the dry potassium to make a liquid. Please explain.
Wednesday, December 30 2015, 10:58 PM
Share this post:

Accepted Answer

Wednesday, November 01 2017, 05:41 PM - #Permalink
Resolved
0 votes
When diluting chemicals, always add the chemical to the water, not the other way around. In general, if you pour water on top of certain chemicals, a reaction can occur quickly causing the solution to splash back up at you. However, if you carefully add the chemical to the water, you can avoid this.

You may find it easier to create a larger volume of properly diluted solution and store it for use as needed.

As an example, let’s assume that you are starting with a household ammonia which is at an 8% solution. If you wanted to make a 4% solution from that, you would combine equal parts water and ammonia. By adding 25ml of ammonia (@ 8% by volume) to 25ml of water you would thus create a 4% solution.

Therefore, to reach a 3.4% solution, you would need to dilute the ammonia by a little more than half.

Once again, let’s assume that you are starting with an 8% ammonia solution. If 50 ml of ammonia solution is required, you would need to add 21ml of ammonia to 28ml of water. (3.4%/8% = .425 -> .425 x 50ml = 21.25ml, or approx. 21ml).

If you should have additional questions, please email support@thamesandkosmos.com
The reply is currently minimized Show
Responses (0)
  • There are no replies here yet.
Your Reply

bottom2

Thames & Kosmos

301 Friendship St.
Providence, RI 02903

Phone: 401-459-6787
Toll-free: 800-587-2872
Fax: 401-459-6775
contact@thamesandkosmos.com